Ultrasonic Cleaning Solution for Marine Engine Motors

Power Sports — Ultrasonic Cleaners Save Time and Money in Power Sports Repairs

If you're still cleaning outboard motors or critical components from motorcycles, ATVs, snowmobiles or jetskis by hand, you're wasting time and resources that could be used to improve service and grow your repair center.

Omegasonics’ easy-to-use ultrasonic cleaning equipment eliminates tedious hand cleaning of complex components such as carburetors, suspensions, inner primaries, fuel injectors, heads, cases and pistons using harsh solvents, saving time and allowing your technicians to perform more valuable work. Minimal disassembly is required: just put the parts in one of our ultrasonic cleaners, turn it on, and walk away. Our products clean the dirtiest parts in a fraction of the time it takes to do the job by hand. Moreover, ultrasonic cleaning is safer and more thorough than hand cleaning — ensuring customer satisfaction and fewer come-backs. Even for smaller shops, our products pay for themselves in a short period of time.

Our ultrasonic cleaners:

  • Reduce cleaning time
  • Clean better, without tear-down
  • Improve productivity — serve more customers
  • Improve cleaning results — especially for sensitive components and hard-to-reach spaces
  • Uses non-toxic, environmentally safe cleaning solutions — no harsh solvents are needed
  • Work with the industry's largest selection of non-toxic ultrasonic soaps

Omegasonics is an approved vendor for American Honda, Harley-Davidson, Yamaha and Mercury Marine.

How Leading Manufacturers Use Our Products

Technicians at Ephrata Cycle and Sports, which sells and repairs racing bikes, cruisers and ATVs, used to spend a lot of time tearing down carburetors and other components for cleaning. Using an Omegasonics® Pro Plus, proprietor Chuck Aughinbaugh has freed his shop of most of this drudgery and virtually eliminated the tough job of cleaning parts with surfaces that are difficult to get at. “When I'm cleaning a four-stack carburetor, I leave them on the plate,” Aughinbaugh explained. “The only things I don't put into the machine (ultrasonic bath) are the occasional vacuum diaphragm.”

Eric Peterson, owner of Specialty Marine in Oxnard, CA, said that his ultrasonic cleaning solution, OmegaClean, removes oil, grease, carbon and other contaminants better than aerosol solvents and hand-cleaning. He likes the fact that the solution is non-toxic and environmentally safe. The cleaner's buffers protect aluminum finishes and its silicates guard against flash rusting. And by charging a flat fee for cleaning a carburetor, his table top unit has become a profit center.

Transmission seal leaks are a tough job on a Harley Davidson. But All American Harley Davidson has shaved about an hour off of the four-hour repair process. “I now remove the inner-primary and put it into the Omegasonics,” said Christian Harms, master technician. “No wiping, no special preparation. While the inner-primary is getting clean, I’m free to replace seals and do other work.”

The fastest, safest way to clean and degrease motor parts

We offer a wide range of ultrasonic machines to meet your shop's needs, from table top cleaners that hold 2-4 carburetors to floor models that can handle larger parts. Click on a link below for more information.

All American Harley-Davidson Case Study

Ephrata Honda Case Study

Speciality Marine Case Study

“Clean and Green”, with Jay Leno, as featured in Popular Mechanics magazine

Sound Waves and Parts Cleaning

What's All The Noise About Ultrasonics?

Model 7800 Table-Top

Model 7900 Table-Top

Quantum Series Ultrasonic Table-Top

Bench-Top Models

Omega® Pro Plus Floor Model

How does an ultrasonic cleaner work?
 
 
© 2010 Omegasonics Corporation. All rights Reserved.